Operation Manual

Problem Possible cause Solution
The room temperature is
too high.
Refer to climate class chart on
the rating plate.
Food products placed in
the appliance were too
warm.
Allow food products to cool to
room temperature before stor-
ing.
The FastFreeze is switched
on.
Refer to "FastFreeze function".
The IntensiveCooling is
switched on.
Refer to "IntensiveCooling func-
tion".
The water drainage plug is
not correctly positioned.
Position the water drainage
plug in the correct way.
Food products are not
wrapped properly.
Wrap the food products better.
Temperature is set incor-
rectly.
Refer to "Operation" .
The compressor does not
start immediately after press-
ing the FastFreeze, or after
changing the temperature.
This is normal, no error has
occurred.
The compressor starts after a
period of time.
The compressor does not
start immediately after press-
ing the IntensiveCooling, or
after changing the tempera-
ture.
This is normal, no error has
occurred.
The compressor starts after a
period of time.
Water flows inside the refrig-
erator.
The water outlet is clog-
ged.
Clean the water outlet.
Food products prevent that
water flows into the water
collector.
Make sure that food products
do not touch the rear plate.
Water flows on the floor. The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
Attach the melting water outlet
to the evaporative tray.
Temperature cannot be set. The FastFreeze or Intensi-
veCooling function is
switched on.
Switch off FastFreeze or Inten-
siveCooling manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FastFreeze or In-
tensiveCooling function".
Progress 33