User manual

Problem Possible cause Solution
Food products placed in
the appliance were too
warm.
Allow food products to cool to
room temperature before stor‐
ing.
The door is not closed cor‐
rectly.
Refer to "Closing the door".
The "FastFreeze" is
switched on.
Refer to "FastFreeze function".
The compressor does not
start immediately after
pressing the "FastFreeze",
or after changing the tem‐
perature.
This is normal, no error
has occurred.
The compressor starts after a
period of time.
Water flows on the rear
plate of the refrigerator.
During the automatic de‐
frosting process, frost
melts on the rear plate.
This is correct.
Water flows inside the refrig‐
erator.
Food products prevent the
water to flow into the wa‐
ter collector.
Make sure that food products
do not touch the rear plate.
The water outlet is clog‐
ged.
Clean the water outlet.
Water flows on the floor. The melting water outlet is
not connected to the evap‐
orative tray above the
compressor.
Attach the melting water outlet
to the evaporative tray.
Temperature cannot be set. The "FastFreeze function"
is switched on.
Switch off "FastFreeze func‐
tion" manually, or wait until the
resets automatically to set the
temperature. Refer to "Fast‐
Freeze function".
The temperature in the ap‐
pliance is too low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera‐
ture.
The door is not closed cor‐
rectly.
Refer to "Closing the door".
The food products' tem‐
perature is too high.
Let the food products temper‐
ature decrease to room tem‐
perature before storage.
Many food products are
stored at the same time.
Add less food products at the
same time.
The door has been
opened often.
Open the door only if necessa‐
ry.
Progress 25