User manual

Problem Possible cause Solution
Water flows on the floor. The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
Attach the melting water out-
let to the evaporative tray.
The temperature in the appli-
ance is too low/too high.
The temperature regulator is
not set correctly.
Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The food products' tempera-
ture is too high.
Let the food products tem-
perature decrease to room
temperature before storage.
Many food products are stor-
ed at the same time.
Store less food products at
the same time.
The thickness of the frost is
greater than 4-5 mm.
Defrost the appliance.
The door has been opened
often.
Open the door only if neces-
sary.
There is too much con-
densed water on the rear wall
of the refrigerator.
Door was opened too fre-
quently.
Open the door only when
necessary.
Door was not closed com-
pletely.
Make sure the door is closed
completely.
Stored food was not wrap-
ped.
Wrap food in suitable pack-
aging before storing it in the
appliance.
Door does not open easily. You attempted to re-open
the door immediately after
closing.
Wait a few seconds between
closing and re-opening of the
door.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
Replacing the lamp
The appliance is equipped with
a longlife LED interior light.
CAUTION! Disconnect the plug
from the mains socket.
1. At the same time, with the fingers
expand up and down the transparent
cover and unhook it in the direction of
the arrows.
24 Progress