User manual
Problem Possible solution
If the delay start is set, cancel the setting or wait for the
end of the countdown.
The appliance does not fill with water. Make sure that the water tap is open.
Make sure that the pressure of the water supply is not
too low. For this information, contact your local water
authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clogged.
Make sure that the inlet hose has no kinks or bends.
The appliance does not drain the water. Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
The anti-flood device is on. Close the water tap and contact the Service.
After the checks are completed, activate
the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the
Service.
If the display shows other alarm codes,
contact the Service.
If the washing and drying results are
not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a
lower position.
• The quantity of detergent is too much.
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is not
sufficient. Adjust the rinse aid selector to
a higher position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying phase
or with a low temperature drying phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent tablets
can be the cause. Try a different brand or
activate the rinse aid dispenser and use
rinse aid together with the combi deter-
gent tablets.
Refer to ‘HINTS AND TIPS’ for other
possible causes.
How to activate the rinse aid dispenser
1. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode, refer to “Setting and
starting a programme”.
2. Press and hold, at the same time, but-
ton
and button until the
indicators of buttons
,
and start to flash.
3.
Press
.
•
The indicators of buttons
and
go off.
•
The indicator of button
con-
tinues to flash.
• The display shows the current setting.
Rinse aid dispenser off.
Rinse aid dispenser on.
4.
Press
to change the setting.
5. Press the on/off button to deactivate the
appliance and to confirm the setting.
6. Adjust the released quantity of rinse aid.
7. Fill the rinse aid dispenser.
TECHNICAL INFORMATION
Dimensions Width / Height / Depth (mm) 596 / 818 - 898 / 575
24 progress