User manual
2.
Then wait 5 seconds: the “Clock”
pilot
lamp will go out and the display will show
the set time. The appliance is now ready
for use.
To reset the correct clock time:
1.
Press the button
repeatedly to select
the “Clock” function. The relevant pilot
lamp will start flashing. Then proceed as
described above.
The clock time can only be reset if no au-
tomatic function (cooking time
or
end of cooking time
) has been set.
Cooking time
When this function is selected, the oven
switches off automatically at the end of a
programmed cooking time. Place the food in
the oven, select a cooking function and set
the cooking temperature required.
Press the button
repeatedly to select the
“Cooking time” function.
The relevant pilot lamp will start flashing.
Then, proceed as follows:
To programme the cooking time:
1.
Press the “
” button or “ ”.
2. After you have set the cooking time, wait
5 seconds: the “Cooking time” pilot lamp
will light up and the display will revert
to the clock time.
3. When the set cooking time has expired,
the oven automatically switches off. An
acoustic signal sounds and the pilot lamp
flashes. Turn the oven and temperature
regulators to zero.
Cancel the acoustic signal by pressing
any button.
NOTE : When the acoustic signal is
switched off, the oven reverts to manual
operation. If the oven and temperature
regulators are not set to zero, the oven
will re-heat.
To cancel a programmed cooking time:
1.
Press the button
repeatedly to select
the “Cooking time” function. The relevant
pilot lamp
will flash and show the re-
maining cooking time.
2.
Press the “
” button until “0:00” ap-
pears in the display. After 5 seconds the
pilot lamp will go out and the display will
revert to the clock time.
End of cooking time
With this function, you can set the oven to
switch off automatically when a programmed
end of cooking time is reached. Place the
food in the oven, select a cooking function
and set the required cooking temperature.
Press the button
repeatedly to select the
“End of cooking” function. The relevant pilot
lamp will start flashing.
progress 31