User manual
sation, operate the appliance for 10 mi-
nutes before cooking.
• Clean the moisture after each use of the
appliance.
• Do not put the objects directly on the ap-
pliance floor and do not put aluminium
foil on the components when you cook.
This can change the baking results and
cause damage to the enamel.
Baking cakes
• Do not open the oven door before 3/4 of
the set cooking time is up.
• If you use two baking trays at the same
time, keep one empty level between
them.
Cooking meat and fish
• Use a deep pan for very fatty food to pre-
vent the oven from stains that can be
permanent.
• Leave the meat for approximately 15 mi-
nutes before carving so that the juice
does not seep out.
• To prevent too much smoke in the oven
during roasting, add some water into the
deep pan. To prevent the smoke con-
densation, add water each time after it
dries up.
Cooking times
Cooking times depend on the type of food,
its consistency, and volume.
Initially, monitor the performance when you
cook. Find the best settings (heat setting,
cooking time, etc.) for your cookware, rec-
ipes and quantities when you use this appli-
ance.
Baking and roasting table
CAKES
TYPE OF DISH
Conventional Cooking
Cooking
time [min]
Notes
Shelf posi-
tion
Temp
[°C]
Whisked recipes 2 170 45 - 60 In a cake mould
Shortbread dough 2 170 24 - 34 In a cake mould
Buttermilk cheese
cake
1 170 60 - 80 In a 26 cm cake mould
Apple cake (Apple
pie)
1 170 100 - 120 In two 20 cm cake moulds on a
wire shelf
Strudel 2 175 60 - 80 In a baking tray
Jam-tart 2 170 30 - 40 In a 26 cm cake mould
Fruit cake 2 170 60 - 70 In a 26 cm cake mould
Sponge cake (Fat-
less sponge cake)
2 170 35 - 45 In a 26 cm cake mould
Christmas cake /
Rich fruit cake
2 170 50 - 60 In a 20 cm cake mould
Plum cake 2 170 50 - 60
In a bread tin
1)
Small cakes 3 170 20 - 30 In a baking tray
Biscuits 3 150 20 - 30
In a baking tray
1)
Meringues 3 100 90 - 120 In a baking tray
Buns 3 190 15 - 20
In a baking tray
1)
Choux 3 190 25 - 35
In a baking tray
1)
Plate tarts 3 180 45 - 70 In a 20 cm cake mould
20 progress