User manual

Problem Possible cause Solution
There is too much frost and
ice.
The door is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
Refer to "Closing the door".
The water drainage plug is
not correctly positioned.
Position the water drainage
plug in the correct way.
Food products are not wrap‐
ped properly.
Wrap the food products bet‐
ter.
Temperature is set incor‐
rectly.
Refer to "Operation" chap‐
ter.
The compressor does not
start immediately after
pressing the "Super", or af‐
ter changing the tempera‐
ture.
This is normal, no error has
occurred.
The compressor starts after
a period of time.
Temperature cannot be set. The "Super function" is
switched on.
Switch off "Super function"
manually, or wait until the
function resets automatically
to set the temperature. Re‐
fer to "Super function".
The temperature in the ap‐
pliance is too low/too high.
The temperature regulator is
not set correctly.
Set a higher/lower tempera‐
ture.
The door is not closed cor‐
rectly.
Refer to "Closing the door".
The food products' tempera‐
ture is too high.
Let the food products tem‐
perature decrease to room
temperature before storage.
Many food products are
stored at the same time.
Store less food products at
the same time.
The thickness of the frost is
greater than 4-5 mm.
Defrost the appliance.
The door has been opened
often.
Open the door only if neces‐
sary.
The Super function is
switched on.
Refer to "Super function".
There is no cold air circula‐
tion in the appliance.
Make sure that there is cold
air circulation in the appli‐
ance.
Door was not closed com‐
pletely.
Make sure the door is
closed completely.
26 Progress