user manual Freezer PG0850
progress Contents Safety information Control panel First use Daily use Helpful Hints and Tips 2 4 5 5 5 Care and cleaning What to do if… Technical data Installation Environmental concerns 6 7 8 9 13 Subject to change without notice Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings.
progress 3 Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel. 1. Power cord must not be lengthened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4. Do not pull the mains cable. 5.
progress shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance marked by the symbol are recyclable. Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish.
progress 5 First use Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brandnew product, then dry thoroughly. Important! Do not use detergents or abrasive powders, as these will damage the finish. Daily use Freezing fresh food The freezer compartment is suitable for freezing fresh food and storing frozen and deep-frozen food for a long time.
progress • prepare food in small portions to enable it to be rapidly and completely frozen and to make it possible subsequently to thaw only the quantity required; • wrap up the food in aluminium foil or polythene and make sure that the packages are airtight; • do not allow fresh, unfrozen food to touch food which is already frozen, thus avoiding a rise in temperature of the latter; • lean foods store better and longer than fatty ones; salt reduces the storage life of food; • water ices, if consumed imme
progress 7 3. Leave the door open and insert the plastic scraper in the appropriate seating at the bottom centre, placing a basin underneath to collect the defrost water 5. Switch on the appliance. 6. After two or three hours, reload the previously removed food into the compartment. In order to speed up the defrosting process, place a pot of warm water in the freezer compartment. In addition, remove pieces of ice that break away before defrosting is complete.
progress Problem The compressor operates continually. The temperature in the freezer is too low. The temperature in the freezer is too high. There is too much frost. Possible cause Solution The temperature is not set correctly. Set a higher temperature. The door is not closed correctly. Refer to "Closing the door". The door has been opened too frequently. Do not keep the door open longer than necessary. The product temperature is too high.
progress 9 Installation Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance.
progress min. 200 cm2 min 1 mm min. 200 cm2 Important! Remove the furniture door damper if possible, to provide free space for the free movement of the appliance door. Installing the appliance Furniture alignment Important! Make sure that the kitchen furniture is aligned vertically and at 90° in all directions. Adjust the kitchen furniture doors before installing the appliance. 90° Caution! Make sure that the mains cable can move freely. Do the following steps: 1. Install the sealing strip.
progress 11 2 1 3. Adjust the appliance in the niche. Align the lower hinge with the kitchen furniture. D C E 6. Disconnect the parts (Ha), (Hb), (Hc) and (Hd). Ha Hb Hc Hd 4. Attach the appliance to the niche with 4 screws. 7. Install the part (Ha) on the inner side of the kitchen furniture. ca. 50 mm 90° I 21 mm 90° ca. 50 mm 5. Attach the covers (C, D) to the lugs and the hinge holes. Attach the hinge cover (E) to the hinge. 21 mm 8. Push the part (Hc) on the part (Ha).
progress 11. Place the small square on the guide again and fix it with the screws supplied. Align the kitchen furniture door and the appliance door by adjusting the part Hb. Ha Hc 9. Open the appliance door and the kitchen furniture door at an angle of 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes. Hb 12. Press the part (Hd) on the part (Hb). 8 mm Hb Ha Hd Hb 10. Remove the brackets.
progress 13 Environmental concerns The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
progress
progress 15
www.progress-hausgeraete.
