user manual Freezer PG0850
progress CONTENTS Safety information Control panel First use Daily use Helpful Hints and Tips 2 4 5 5 5 Care and cleaning 6 What to do if… 7 Technical data 8 Installation 9 Environmental concerns 12 Subject to change without notice SAFETY INFORMATION In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings.
progress 3 • • • • 2. Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4. Do not pull the mains cable. 5. If the power plug socket is loose, do not insert the power plug. There is a risk of electric shock or fire. 6. You must not operate the appliance without the lamp cover1) of interior lighting. This appliance is heavy.
progress shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance marked by the symbol are recyclable. Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish.
progress 5 FIRST USE Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brandnew product, then dry thoroughly. Important! Do not use detergents or abrasive powders, as these will damage the finish. DAILY USE Freezing fresh food The freezer compartment is suitable for freezing fresh food and storing frozen and deep-frozen food for a long time.
progress • prepare food in small portions to enable it to be rapidly and completely frozen and to make it possible subsequently to thaw only the quantity required; • wrap up the food in aluminium foil or polythene and make sure that the packages are airtight; • do not allow fresh, unfrozen food to touch food which is already frozen, thus avoiding a rise in temperature of the latter; • lean foods store better and longer than fatty ones; salt reduces the storage life of food; • water ices, if consumed imme
progress 7 3. Leave the door open and insert the plastic scraper in the appropriate seating at the bottom centre, placing a basin underneath to collect the defrost water 5. Switch on the appliance. 6. After two or three hours, reload the previously removed food into the compartment. In order to speed up the defrosting process, place a pot of warm water in the freezer compartment. In addition, remove pieces of ice that break away before defrosting is complete.
progress Problem The compressor operates continually. The temperature in the freezer is too low. The temperature in the freezer is too high. There is too much frost. Possible cause Solution The temperature is not set correctly. Set a higher temperature. The door is not closed correctly. Refer to "Closing the door". The door has been opened too frequently. Do not keep the door open longer than necessary. The product temperature is too high.
progress 9 INSTALLATION Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance.
progress min. 200 cm2 2 min. 200 cm2 Installing the appliance Caution! Make sure that the mains cable can move freely. Do the following steps: 1. If necessary cut the adhesive sealing strip and then apply it to the appliance as shown in figure. 1 3. Adjust the appliance in the niche. The lower hinge cover (in the accessories bag) makes sure that the distance between the appliance and the kitchen furniture is correct. Open the door. Put the lower hinge cover in position. x 4mm 44mm x 4.
progress 11 7. Disconnect the parts (Ha), (Hb), (Hc) and (Hd). Ha I Hb Hc 5. Remove the correct part from the hinge cover (E). Make sure to remove the part DX, in the case of right hinge, SX in opposite case. Hd 8. Install the part (Ha) on the inner side of the kitchen furniture. ca. 50 mm 90° 21 mm 90° ca. 50 mm 6. Attach the covers (C, D) to the lugs and the hinge holes. Attach the hinge covers (E) to the hinge. 21 mm 9. Push the part (Hc) on the part (Ha).
progress 10. Open the appliance door and the kitchen furniture door at an angle of 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes. 8 mm Hb 13. Press the part (Hd) on the part (Hb). Ha Hb 11. Remove the brackets and mark a distance of 8 mm from the outer edge of the door where the nail must be fitted (K). Hb 8 mm Hd Do a final check to make sure that: • All screws are tightened.
progress 13 your household waste disposal service or the shop where you purchased the product.
progress
progress 15
www.electrolux.
