Operation Manual

CARE AND CLEANING
Important! The risk of burns from residual
heat!
Let the appliance become sufficiently cool.
Clean the appliance after each use.
Always use cookware with clean bottom.
Scratches or dark stains on the surface
cause no effect on how the appliance
operates.
To remove the dirt:
1. Use the cleaning powder or the clean-
ing pad.
2. Clean the appliance with a moist cloth
and some detergent.
3. Heat the hotplate to a low temperature
and let it to dry.
4. To keep the hotplates in good shape,
regularly rub in a sewing machine oil.
Polish off the oil with absorbent paper.
Important! For stainless steel edges of the
hob use the cleaning agent for stainless
steel.
The stainless steel edge of the plate
can change the colour as a result of
the high temperature.
The stainless steel can become dirty if the
temperature is too high. Because of this do
not cook with the stone pots, earthenware
pans or cast iron plates. Do not use the alu-
minium foil to prevent damage to the top
during operation.
The Stainless steel parts wash with water,
and then dry with a soft cloth.
TROUBLESHOOTING
Problem Possible cause Remedy
You cannot activate the appli-
ance or operate it.
Activate the appliance again
and set the heat setting in less
than 10 seconds.
Problem with the house electri-
cal system.
Examine the fuse in the electri-
cal system of the house in the
fuse box. If the fuses blow
again and again, speak to
qualified electrician.
If you tried the above solutions and cannot
repair the problem, speak to your dealer or
the customer service. Give the data from
the rating plate, three digit letter code for
the glass ceramic (it is in the corner of the
glass surface) and an error message that
comes on.
Make sure, you operated the appliance cor-
rectly. If not the servicing by a customer
service technician or dealer will not be free
of charge, also during the warranty period.
The instructions about the customer service
and conditions of guarantee are in the guar-
antee booklet.
INSTALLATION
Warning! Refer to "Safety information"
chapter.
Before the installation
Before the installation of the appliance, re-
cord the information below from the rating
plate. The rating plate is on the bottom of
the appliance casing.
• Model ...........................
• PNC .............................
• Serial number ....................
Built-in appliances
• Only use the built-in appliances after you
assemble the appliance into correct built-
in units and work surfaces that align to
the standards.
progress 11