User manual

38
progress
Connections
DUCTING VERSION AIREXHAUST SYS-
TEM
When installing the hood in ducting version, a rigid
oraexiblepipewiththediametercorresponding
totheangediameterisusedinordertoconnect
the hood to the air outlet piping.
• Fixthepipewithanadequatequantityofpipe
clamps (not supplied).
• Remove possiblecharcoallters.
RECIRCULATION VERSION AIREOUT-
LET
• Cut a hole ø 125 mm in any shelf that may
be posi-tioned over the hood.
• Connect theangeto the outleton the shelf
over the hood using a exible or rigid pipe
ø120 mm.
• Fix the pipe in position using sufcient pipe
clamps (not supplied).
• Fix thedirectionalgrille8 on the recirculation
air outlet using the 2 screws 12e (2,9 x 12,7)
provided.
• Ensurethattheactivatedcharcoalltershave
been inserted.
ELECTRICAL CONNECTION
• Connect the hood to the mains through a
two-pole switch having a contact gap of at
least 3 mm.
• Whenopeningtheslidingcarriagefortherst
time after installing the hood, pull it out briskly
until it clicks.




