User manual

37
progress
INSTALLATION
Drilling the Support surface and Fitting
the Hood
SCREW FITTING
• The hood support surface must be 135
mm above the bottom surface of the wall
units.
• Drillthesupportwithaø4,5mmdrillbit,
using the drilling template provided.
• Cutaholeø125mminsizeonthesup-
port surface, using the drilling template
provided.
• Fix using the 4 screws 12a (4,2 x 44,4)
provided.
SNAP-ON FITTING
• The hood can be installed either directly
on the bottom surface of the wall units us-
ing snap-on side supports.
• Cutattedopeninginthebottomsurface
of the wall unit, as shown.
• Insert the hood until the side supports
snap into place.
• Lockinpositionbytighteningthescrews
Vf from underneath the hood.
CLOSING ELEMENT
• Thespacebetweentheedgeofthehood
and the rear wall can be closed by apply-
ing the element 20 provided, using the
screws supplied for this purpose.







