User manual

If the function Descaling is not
performed in the correct way,
the display will show a
message to repeat it.
If the appliance is humid and wet, wipe it
out with a dry cloth. Let the appliance dry
fully with the door open.
Descaling reminder
There are two descaling reminders which
remind you to perform the function:
Descaling. These reminders activate each
time you switch off the appliance. When
reminder is active S3 flashes in the
display.
• The soft reminder reminds and
recommends you to perform the
descaling cycle.
• The hard reminder obligates you to
perform the descaling. If you do not
descale the appliance when the hard
reminder is on, you cannot use the
steam functions. You cannot disable
the descaling reminder.
Steam generation system -
Rinsing - S4
Remove all accessories.
The duration of the function is around 30
minutes.
The light in this function is off.
1. Put the tray on the first shelf position.
2. Fill the water drawer with fresh water
to the maximum level until the acoustic
signal sounds or the display shows the
message.
3. Activate Rinsing function - S4. Refer to
"Activating a cleaning function".
Remove the tray after the end of the
procedure.
Replacing the lamp
WARNING! Risk of electric
shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
The top lamp
1. Turn the lamp glass cover to remove it.
2. Remove the metal ring and clean the
glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Attach the metal ring to the glass
cover.
5. Install the glass cover.
TROUBLESHOOTING
WARNING! Refer to Safety
chapters.
What to do if...
Problem Possible cause Remedy
You cannot activate or oper‐
ate the oven.
The oven is not connected
to an electrical supply or it is
connected incorrectly.
Check if the oven is correct‐
ly connected to the electrical
supply (refer to the connec‐
tion diagram if available).
44 Progress