User manual

4. Let the appliance operate without the
food for approximately 10 minutes.
5.
Set function
and maximum temper-
ature.
6. Let the appliance operate without the
food for approximately 10 minutes.
This is to burn off the residue in the appli-
ance. The accessories can become more
hot than usually. When you pre-heat the
appliance for the first time, the appliance
can make an odour and smoke. This is the
usual effect. Make sure the airflow is suffi-
cient.
DAILY USE
Warning! Refer to "Safety information"
chapter.
The display
1 2 3
1 Cooking function
2 Temperature
3 Time
Button Function Description
ON/OFF To switch the appliance on or off.
SELECTOR To set the oven function.
RAPID HEAT UP To switch the rapid heat-up function on.
PYROLYTIC CLEANING To start the Pyrolytic cleaning.
/
PLUS, MINUS To adjust the values (temperature and time).
CLOCK To set the clock function.
Setting the oven function
12
1.
Push
again and again until the sym-
bol for the necessary oven function
flashes.
The display shows an automatic tem-
perature. If you do not change the tem-
perature in approximately 5 seconds,
the appliance starts to operate.
2.
To change the temperature, push
or
button.
If you start an oven function, the sym-
bol of the temperature
flashes.
The symbol shows that the tempera-
ture in the appliance increases.
When the appliance is at the set tem-
perature, an acoustic signal sounds
and the symbol of the temperature
stops to flash.
If there is a power cut, the programmer
keeps all the settings for approximately
3 minutes. After more than 3 minutes
without power supply, you have to do
the settings (also the time of day)
again.
26 progress