User manual

CAUTION! If there are other
appliances installed in the same
cabinet, do not use them at the
same time as the Pyrolysis
function. It can cause damage
to the appliance.
During the pyrolytic cleaning the door is
locked. The symbol and the bars of the
heat indicator come up, until the door
unlocks. The door unlocks when the
temperature inside the oven is under safety
conditions and the pyrolytic cleaning
finishes.
During the pyrolytic cleaning the lamp is
deactivated.
1.
Remove the worst dirt manually.
2.
Clean the inner side of the door with hot
water, so that the residues do not burn
from the hot air.
3.
Set the Pyrolysis function (refer to
"Oven functions").
4. Touch
or to set the duration of
the cleaning procedure:
Option Description
1 1:00 h for a low
degree of dirt
2 1:30 h for a usual
degree of dirt
3 2:30 h for a high
degree of dirt
You can use the End function to delay
the start of the cleaning procedure.
5. Touch to activate the Pyrolysis
function.
Cleaning reminder
To remind you that the pyrolytic cleaning is
necessary, the cleaning reminder symbol
flashes in the display after each
deactivation of the appliance for the next 10
seconds.
The cleaning reminder goes
out:
• after the end of the pyrolytic
cleaning.
• when you deactivate it in the
basic settings. Refer to
"Using the settings menu".
Removing and installing the
door
You can remove the door and the internal
glass panels to clean it. The number of
glass panels is different for different models.
WARNING! Be careful when
you remove the door from the
appliance. The door is heavy.
1.
Open the door fully.
2.
Fully press the clamping levers (A) on
the two door hinges.
A
A
3. Close the oven door to the first opening
position (approximately 70° angle).
4. Hold the door with one hand on each
side and pull it away from the appliance
at an upwards angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface. This
is to prevent scratches.
6. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
Progress 31