User manual

This means that, before activating the py-
rolytic cleaning function, you have to re-
move all the oven accessories and the
side rails from the oven cavity (see the
previous chapter).
2.
The Cooking Time symbol
will flash
for some seconds; during this time push
the button ‘
’ or ‘ ’ to select the
pyrolytic 1 (P I) or pyrolytic 2 (P 2) func-
tion.
3. Once you have chosen the desired pyro-
lytic function, Pyro will flash in the display
waiting for confirmation to start the pyro-
lytic cleaning function.
At this time, push the time function button
.
“The End of Cooking” symbol
and
the arrow symbol
flash. On the control
panel, the cleaning cycle (that is, the ac-
tual time + cooking time) will displayed.
1
2
Press the ‘ ’ or ‘ ’ buttons to select
the required end of cycle time.. After a
few seconds, the word Pyro and the
symbol
will stop flashing, the acoustic
signal will stop while the Cooking time
symbol
will flash until the pyrolytic
cleaning cycle starts.
4. After some time the door lock will be Ac-
tivated and the respective symbol
will
be displayed.
At the end of the pyrolytic cleaning process,
the display shows the time of day. The oven
door is locked.
Once the oven has cooled down, an acoustic
signal will be emitted and the door will unlock.
To stop the pyrolitic cleaning cycle at any
time: press the button
.
The oven door
The oven door consists of three panes of
glass. The oven door can be disassembled
and the internal panes can be removed to
make cleaning easier.
Important! Remove the oven door before
cleaning it. The oven door could abruptly
close if you try to remove the internal
panes of glass when the door is still
assembled.
To do so, proceed as follows:
1. open the door fully.
2. Locate the two door hinges
3. Lift and turn the levers on the two hinges
4. Hold the door by the side edges and
close it slowly but not COMPLETELY
5. Pull the door forward, removing it from its
seat
progress 47