User manual

Temperature set-
ting:
the oven will switch
off:
250ºC after 3 hours
from 200 up to 245°C after 5.5 hours
from 120 up to 195°C after 8.5 hours
less than 120°C after 12 hours
Residual heating function
When a cooking time is set, the oven will au-
tomatically switch off a few minutes before
the end of the programmed time, and use the
residual heat to finish your dishes without en-
ergy consumption.
All current settings will be displayed until the
cooking time is over.
This function will not operate when the cook-
ing time is less than 15 minutes.
Child lock for the oven
To prevent children from switching on the
oven, it is possible to lock the oven controls.
1.
Turn off the oven by pressing button
.
2.
Press the
and “ “ buttons at the
same time for about 3 seconds. An
acoustic signal will be emitted and the in-
dication ‘ SAFE ’ will appear in the display
3. The oven is now locked. Neither oven
functions nor temperatures can be selec-
ted.
To unlock the oven:
Press the
and “ ” at the same time and
keep them pressed for about 3 seconds.
An acoustic signal will be emitted and the in-
dication “SAFE” will go out.
The oven can now be operated.
Fast heat-up function
After a cooking function and the temperature
have been selected, the cavity will gradually
heat up until the selected temperature is
reached.
This will take from 10 to 15 minutes, depend-
ing on the selected function and tempera-
ture.
If it is necessary to reach the required tem-
perature in a shorter time, the “Fast Heat Up”
function can be used.
1. Switch the oven on by pressing button
.
2. Set the required cooking function and
temperature as explained in the previous
pages.
3. Set the temperature by pressing button “
" or “ ”. The temperature will appear
in the display.
4.
Press the button
. The temperature
display will show “ FHU ”
5.
Press the button
The symbol “ ° ” will
flash for approximately 10 seconds. Now
it is possible to select the required tem-
perature. To do this, press the button
“
” or “ ”.
6. When the required temperature is
reached, the electronic control beeps for
a short time, and the temperature display
reverts to the selected temperature.
This function can be used with any cooking
function or temperature.
Demo mode
This mode is intended to be used in shops to
demonstrate the oven functionality without
any power consumption except the interior
light, the display and the fan.
This function can only be switched on when
the appliance is first connected.
If there is a power failure, when the power
supply is restored again the Demo function
can only be switched on if, in the display,
38 progress