Operation Manual

7. Carefully lift (step 1) and remove (step 2)
the panels of glass one by one. Start
from the top panel of glass.
1
2
Clean the glass panels with water and
soap. Dry the glass panels carefully.
Installing the door and the glass panels
When the cleaning is completed, install the
glass panels and the oven door. Do the
above steps in the opposite sequence.
The middle panel has a decorative frame.
When you install this panel, make sure that
the screen-printing zone looks to the inner
side of the door. Make sure that after the
installation the surface of the glass panel
frame on the screen-printing zones is not
rough when you touch it.
Make sure that you install the middle panel
of glass in the seats correctly (refer to the il-
lustration).
Make sure that you install the top panel of
glass in the seats correctly (refer to the illus-
tration).
WHAT TO DO IF…
Warning! Refer to "Safety information"
chapter.
Problem Possible cause Remedy
The appliance does not
heat up.
The appliance is deactivated. Activate the appliance.
The clock is not set. Set the clock.
The necessary settings are not set. Do a check of the settings.
The automatic switch-off is on. Refer to "Automatic switch-off".
The Child lock is on. Refer to "Deactivating the Child
Lock".
The fuse in the fuse box is re-
leased.
Do a check of the fuse.
If the fuse is released more than
one time, contact a qualified elec-
trician.
The oven lamp does not
operate.
The oven lamp is defective. Replace the oven lamp.
progress 35