Operation Manual

3.
Press
to start the Pyrolytic cleaning.
The bars on the symbol
come on one by
one to show that the temperature in the ap-
pliance increases.
When the appliance is at the preset temper-
ature, the door locks and the display shows
.
When the Pyrolytic cleaning is completed,
the display shows the time of day. The oven
door is locked. When the appliance cools
down, an acoustic signal sounds and the
door unlocks.
To stop the pyrolytic cleaning at any
time, press
.
End time for Pyrolytic cleaning
You can set the end time for Pyrolytic
cleaning with the clock function End
.
1. Do again step 1, 2 and 3 from
above procedure.
2.
Press
.
3.
The display shows an arrow
and the symbol . The display
shows the time for the end of Pyro-
lytic cleaning.
4.
Press
or to adjust the time
for the end of the Pyrolytic clean-
ing.
Shelf Support Rails
Removing the shelf support rails
1. Pull the front of the shelf support rail
away from the side wall.
2. Pull the rear shelf support rail away
from the side wall and remove it.
Installing the shelf support rails
Install the shelf support rails in opposite se-
quence.
The rounded ends of the shelf support
rails must point to the front!
Oven lamp
Warning! Be careful! There is the risk
of electrical shock!
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or
switch off the circuit breaker.
Put a cloth on the bottom of the oven
for protection of the oven light and
glass cover.
1. Turn the glass cover anti-clockwise to
remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with appli-
cable 300°C heat-resistant oven light
bulb.
Use the same oven lamp type.
4. Install the glass cover.
Cleaning the oven door
The oven door has three panels of glass.
You can remove the oven door and the in-
ternal panels of glass to clean them.
The oven door can close if you try to
remove the panels of glass before you
remove the oven door.
progress 33