Operation Manual

61 progress
2. Press the bottons and “ ” at the
same time. A short acoustic alarm will be
heard and the time 12:00 appears in the
display (Fig. 15).
When the oven is switched on, the
symbol appears
in the display.This
means that the demo function is activated.
All oven functions can be selected.
The oven is not really working and the
heating elements do not switch on.
Switch off the oven and follow the above
described procedure to disable the demo
mode.
The demo mode remains saved in the
programme in the event of a power
failure.
Beep on touch
You can choose to make the electronic
contr
ol beep each time that a button is
p
ressed. To enable this function, the oven
must be off.
1. Press the buttons
and “ ” at the
same time and keep them pressed for
about 3 seconds. The alarm signal beeps
once (Fig. 16).
To disable the beep on touch:
1. With the oven switched on, press the
button
to switch the oven off.
2. Press the buttons
and “ ” at the
same time and keep them pressed for
about 3 seconds. The electronic control
beeps once.
Error codes
The electronic programmer does a
continuous diagnostic check of the system.
If some parameters ar
e not correct, the
control unit will stop the activated functions
and it will display the corresponding error
code (Fig. 17).
For further details, refer to chapter
“Troubleshooting”.
Fig. 15
Fig. 17
Fig. 16