Operation Manual

60 progress
Fast heat-up function
After a cooking function and the tem-
perature have been selected, the cavity will
gradually heat up until the selected tempera-
ture is reached. This will take from 10 to 15
minutes, depending on the selected function
and temperature.
If it is necessary to reach the required
temperature in a shorter time, the “Fast Heat
Up” function can be used.
1. Switch the oven on by pressing button
.
2. Set the required cooking function and
temperature as explained in the previous
pages.
3. Set the temperature by pressing button
“
” or “ ”. The temperature will appear
in the display.
4. Press the buttons . The temperature
display will show “FHU” (Fig. 14).
5. Press the buttons
The symbol “°” will
flash for approximately 10 seconds. Now
it is possible to select the required tem-
perature. To do this, press the button
“
” or “ ”.
6. When the required temperature is
reached, the electronic control beeps for
a short time, and the temperature display
reverts to the selected temperature.
This function can be used with any
cooking function or temperature.
Demo mode
This mode is intended to be used in
shops to demonstrate the oven functionality
without any power consumption except the
interior light, the display and the fan. This
function can only be switched on when the
appliance is first connected.
If ther
e is a power failur
e, when the power
supply is restored again the Demo function
can only be switched on if, in the display,
12:00 and the symbol
are flashing
automatically.
1. Press the button
for approx. 2
seconds. A short acoustic alarm will be
heard.
Fig. 14