User manual

1
2
Install the shelf supports in the opposite
sequence.
Oven ceiling
WARNING! Deactivate the
appliance before you remove
the heating element. Make sure
that the appliance is cold. There
is a risk of burns.
Remove the shelf supports.
You can fold down the heating element on
the oven ceiling to clean the oven ceiling
easily.
1. Hold the heating element with two
hands at the front.
2. Pull it forwards against the spring
pressure and out along the supports on
the two sides.
The heating element folds down.
3. Clean the oven ceiling.
4. Install the heating element in the
opposite sequence.
Install the heating element
correctly above the supports on
the inner walls of the appliance.
5.
Install the shelf supports.
Removing and installing the
door
You can remove the door and the internal
glass panels to clean it. The number of
glass panels is different for different models.
WARNING! Be careful when
you remove the door from the
appliance. The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A) on
the two door hinges.
A
A
3.
Close the oven door to the first opening
position (approximately 70° angle).
4.
Hold the door with one hand on each
side and pull it away from the appliance
at an upwards angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface. This
is to prevent scratches.
6. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
1
2
B
7. Pull the door trim to the front to remove
it.
8. Hold the door glass panels on their top
edge one by one and pull them up out
of the guide.
30 Progress