User manual

Turn the oven and temperature regula-
tors to zero.
Cancel the acoustic signal by pressing
any button.
NOTE : When the acoustic signal is
switched off, the oven reverts to manual
operation. If the oven and temperature
regulators are not set to zero, the oven
will re-heat.
To cancel the programmed end of cooking
time:
1.
Press the button
repeatedly to select
the “End of cooking time” function. The
relevant pilot lamp
will flash and the
display will show the programmed end of
cooking time.
2.
Press the “
” button until the clock time
appears in the display. An acoustic signal
sounds and the pilot lamp goes out.
Cook time
and End time
combined
The “Cooking time” and “End of cooking
time” functions can be used at the same time
so that the oven automatically switches on
and off at a later time.
1.
Using the “Cooking time” function
set the cooking time (as described in the
relevant chapter). Then, press the button
: the display will show the program-
med setting.
2. Using the “End of cooking time” function
set the end of cooking time (as de-
scribed in the relevant chapter). The rel-
evant pilot lamps will light up and the dis-
play will show the clock time. The oven
will switch on and off according to the set
programmes.
Minute minder
The minute minder signal beeps at the end
of a set time; but the oven remains switched
on ready for use.
To set the minute minder:
1.
Press the button
repeatedly to select
the “Minute minder” function. The rele-
vant pilot lamp
will start flashing.
2.
Then, press the “
” button or “ ”
button (maximum time: 2 hours, 30 mi-
nutes).
3. After you have set the minute minder, wait
5 seconds: the “Minute minder” pilot
lamp lights up.
4. When the end of the set time is reached,
the display begins to flash and an acous-
tic signal sounds. To cancel the acoustic
signal, press any button.
To cancel the minute minder:
1.
Press the button
repeatedly to select
the “Minute minder” function. The rele-
vant pilot lamp
will flash and the dis-
play will show the remaining time.
2.
Press the “
” button until “0:00” ap-
pears in the display. After 5 seconds the
pilot lamp will go out and the display will
revert to the clock.
To switch off the display
1. Press the two programming buttons at
the same time and hold them down for
about 5 seconds. The display will switch
off.
2. To switch on the display again, press any
button.
The display can be switched off only if
no other functions have been set.
32 progress