User manual

The side lamp
1. Remove the left shelf support to get
access to the lamp.
2. Use a Torx 20 screwdriver to remove
the cover.
3. Remove and clean the metal frame and
the seal.
4. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
5. Install the metal frame and the seal.
Tighten the screws.
6. Install the left shelf support.
TROUBLESHOOTING
WARNING! Refer to Safety
chapters.
What to do if...
Problem Possible cause Remedy
The appliance does not heat
up.
The appliance is deactivated. Activate the appliance.
The appliance does not heat
up.
The clock is not set. Set the clock.
The appliance does not heat
up.
The necessary settings are
not set.
Make sure that the settings
are correct.
The appliance does not heat
up.
The automatic switch-off is
activated.
Refer to "Automatic switch-
off".
The appliance does not heat
up.
The Child Lock is on. Refer to "Using the Child
Lock".
The appliance does not heat
up.
The fuse is released. Make sure that the fuse is the
cause of the malfunction. If
the fuse releases again and
again, contact a qualified
electrician.
The lamp does not operate. The lamp is defective. Replace the lamp.
The display does not show
the time during the off status.
The display is deactivated.
Touch and at the
same time to activate the dis-
play again.
It takes too long to cook the
dishes or they cook too
quickly.
The temperature is too low or
too high.
Adjust the temperature if
necessary. Follow the advice
in the user manual.
Steam and condensation set-
tle on the food and in the
cavity of the oven.
You left the dish in the oven
for too long.
Do not leave the dishes in the
oven for longer than 15 - 20
minutes after the cooking
process ends.
Progress 21