User manual
Stainless steel or aluminium
ovens
Clean the oven door with a damp cloth or
sponge only. Dry it with a soft cloth.
Do not use steel wool, acids or abrasive
materials as they can damage the oven
surface. Clean the oven control panel with
the same precautions.
Cleaning the cavity
embossment
The cleaning procedure removes
limestone residue from the cavity
embossment after cooking with steam.
For the function: True Fan
Cooking PLUS we recommend
to do the cleaning procedure at
least every 5 - 10 cooking
cycles.
1. Put 250 ml of white vinegar into the
cavity embossment at the bottom of
the oven.
Use maximum 6% vinegar without any
additives.
2. Let the vinegar dissolve the residual
limestone at the ambient temperature
for 30 minutes.
3. Clean the cavity with warm water and
a soft cloth.
Cleaning the door gasket
Regularly do a check of the door gasket.
The door gasket is around the frame of
the oven cavity. Do not use the oven if the
door gasket is damaged. Contact an
Authorised Service Centre.
To clean the door gasket, refer to the
general information about cleaning.
Removing the shelf supports
To clean the oven, remove the shelf
supports.
CAUTION! Be careful when
you remove the shelf supports.
1. Pull the front of the shelf support away
from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove it.
2
1
Install the removed accessories in the
opposite sequence.
Removing and installing door
The oven door has two glass panels. You
can remove the oven door and the internal
glass panel to clean it. Read the whole
"Removing and installing door" instruction
before you remove the glass panels.
The oven door may close if you
try to remove the internal glass
panel before you remove the
oven door.
CAUTION! Do not use the
oven without the internal glass
panel.
1. Open the door fully and hold both
hinges.
24 Progress