Operation Manual

Remove
Type of dirt immediately when the appliance
has cooled down
using
fat splashes --- yes cleaner for glass ceramic
or stainless steel *
shiny metallic discolor-
ation
--- yes cleaner for glass ceramic
or stainless steel *
* Scrapers and cleaners for glass ceramic
and stainless steel can be purchased in spe-
cialist shops
Remove stubborn residues with a clean-
er for glass ceramic or stainless steel.
Scratches or dark stains on the glass
ceramic that cannot be removed do not
however affect the functioning of the ap-
pliance.
What to do if …
Problem Possible cause Remedy
The cooking zones will not
switch on or are not functioning
More than 10 seconds have
passed since the appliance was
switched on
Switch the appliance on again.
The child safety device is switch-
ed on
Deactivate child safety device
(See the section “Child safety
device”)
Several sensor fields were
touched at the same time
Only touch one sensor field
Automatic switch off has been
triggered
Remove any objects (pan,
cloths, etc.) that are lying on the
control panel. Switch the appli-
ance on again
The residual heat indicator is not
displaying anything
The cooking zone was only on
for a short time and is therefore
not hot
If the cooking zone is supposed
to be hot, call the Customer
Service Department.
The appliance switches itself on
and then off again.
The On/Off sensor field has
been covered up, e.g. by a cloth
Do not place any objects on the
control panel
is lit
Overheating protection for the
cooking zone has been trig-
gered
Switch off the cooking zone.
Switch the cooking zone on
again
Automatic switch off has been
triggered
Switch off the cooking zone.
Switch the cooking zone on
again
and number are displayed
Electronics fault Disconnect the appliance from
the electrical supply for a few mi-
nutes (Take the fuse out of the
house’s wiring system) If after
switching on again,
is dis-
played again, call the customer
service department
If you are unable to remedy the problem
by following the above suggestions,
please contact your dealer or the Cus-
tomer Care Department.
Warning! Repairs to the appliance are
only to be carried out by qualified service
engineers. Considerable danger to the
user may result from improper repairs.
progress 19