Operation Manual

Electrical connection
• Make sure that the rated voltage and
type of power on the rating plate agree
with the voltage and the power of the lo-
cal power supply.
• This appliance is supplied with a mains
cable and a plug.
• Always use a correctly installed shock-
proof socket.
• Make sure that there is an access to the
mains plug after the installation.
• Do not pull the mains cable to disconnect
the appliance. Always pull the mains
plug.
• There is a risk of fire when the appliance
is in connection with an extension cable,
an adapter or a multiple connection.
Make sure that the ground connection
agrees with the standards and regula-
tions.
• Do not let the power cable to heat up to
a temperature higher than 90° C.
Make sure that you connect the blue neu-
tral cable to the terminal with a letter "N" on
it. Connect the brown (or black) phase ca-
ble to the terminal which has a letter "L".
Keep the phase cable connected at all
times.
Replacement of the connection cable
To replace the connection cable use only
H05V2V2-F T90 or equivalent type. Make
sure that the cable section is applicable to
the voltage and the working temperature.
The yellow/green earth wire must be ap-
proximately 2 cm longer than the brown (or
black) phase wire.
Building In
min.
55 mm
min.
650 mm
560 mm
480 mm
min.
100 mm
30 mm
10 mm
3 mm
11 mm
11 mm
A
A
B
A) supplied seal
B) supplied brackets
Caution! Install the appliance only on a
worktop with flat surface.
Possibilities for insertion
Kitchen unit with door
The panel installed below the hob must be
easy to remove and let an easy access in
case a technical assistance intervention is
necessary.
min 20 mm
(max 150 mm)
30 mm
60 mm
B
A
A) Removable panel
B) Space for connections
progress 23