Installation Guide

ManualsBrandsProgress Lighting ManualsCommercial LightingWaystar Series 25-Watt Black Integrated LED Emergency Light

WARNING – This product contains chemicals known to the State of California to cause cancer, birth

defects and/or other reproductive harm. Thoroughly wash hands after installing, handling, cleaning,

or otherwise touching this product.

Emergency Lighting Equipment For Use in Damp Locations

Damp location listed units are suitable for installation in:

1. Interior locations subject to moderate degrees of moisture, such as some basements, some barns,

some c

old storage warehouses, and the like.

2. Partially protected locations under canopies, marquees, roofed open porches and the like.

Twin Dual-Head LED Emergency Lighting

Unit Standard and Self Diagnostic Models

Installation, Operation, and Service Instructions

PECEM Series

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should

always be followed including the following.

READ AND FOLLOW ALL SAFETY

INSTRUCTIONS

1. Do not use outdoors.

2. Do not let power supply cords touch hot surfaces.

3. Do not mount near gas or electric heaters.

4. Equipment should be mounted in locations and at heights where it will not readily be

subject to tampering by unauthorized personnel.

5. The use of accessory equipment not authorized by the manufacturer may cause an

unsafe condition.

6. Do not use this equipment for other than its intended purpose.

7. Servicing of this equipment should be performed by

service personnel.

8. Test cycling: the Life Safety Code (NFPA 101) requires testing of emergency lighting units

once a month for a minimum of 30 seconds, and once a year for a minimum

of 90 minutes.

INSTALLER:

•SEE UNIT LABEL FOR ADDITIONAL MODEL SPECIFICATIONS

•SAVE THESE INSTRUCTIONS FOR USE BY OWNER/OCCUPANT

Summary of content (5 pages)

PAGE 1
PECEM Series Twin Dual-Head LED Emergency Lighting Unit Standard and Self Diagnostic Models Installation, Operation, and Service Instructions IMPORTANT SAFEGUARDS When using electrical equipment, basic safety precautions should always be followed including the following. READ AND FOLLOW ALL SAFETY INSTRUCTIONS 1. 2. 3. 4. 5. 6. 7. 8. Do not use outdoors. Do not let power supply cords touch hot surfaces. Do not mount near gas or electric heaters.
PAGE 2
BACKBOX INSTALLATION BACKBOX INSTALLATION This unit is designed to be mounted in the ceiling. Provide standard unit with a single unswitched supply from a 120-277VAC, 50/60Hz branch circuit used for normal lighting in area to be protected. For self-testing/self-diagnostic unit, provide unit with a 120VAC or 277VAC 50/60Hz branch circuit.
PAGE 3
FIXTURE INSTALLATION FIXTURE INSTALLATION Step 1 The PECEM is packaged with the rectangular face attached. If so desired, remove the rectangular face and replace it with the round. OR Step 2 93067922 The PECEM unit is equipped with intelligent wiring. Connect the black wire from the unit to the hot building wire (120-277VAC 50/60Hz), the white wire to the neutral building wire, and the building ground to the green ground wire mounted inside the enclosure. Secure all with wire nuts.
PAGE 4
OPERATION OPERATION “AC ON” LED is illuminated when AC power is present. NOTE: All models are supplied with an AC Lockout circuit, which prevents the emergency lights from illuminating when the battery is connected and no AC power is present. NOTE: All models are supplied with a Low Voltage Disconnect circuit, which prevents damage to the battery from deep discharge during prolonged emergency operation. NOTE: Batteries are often shipped in a discharged state – this is normal.
PAGE 5
SERVICE/MAINTENANCE SERVICE / MAINTENANCE Maintenance This emergency lighting unit should be tested and maintained in accordance with National Electrical Code and NFPA 101 Life Safety Code requirements. It is recommended that emergency light fixtures be tested for 30 seconds once a month and for 90 minutes once a year.