Installation Guide

RECYCLING INFORMATION

All steel, aluminum and thermoplastic parts are recyclable.

NOTICE: Emergency units contain rechargeable batteries

which must be recycled or disposed of properly.

Progress Commercial Lighting • progresscommercial.com

subject to change without notice.

93071383_A 416

SERVICE / MAINTENANCE

SERVICE/MAINTENANCE

Maintenance

This emergency lighting unit should be tested and maintained in accordance with National Electrical Code and NFPA 101 Life Safety

Code requirements. It is recommended that emergency light fixtures be tested for 30 seconds once a month and for 90 minutes once a

year.

Taking A Unit Out Of Service

If a unit is to be deliberately taken out of service for an extended period, the battery lead connector should be disconnected from the

charger circuit board and insulated so that the battery will go into storage in a fully charged condition.

Replacing The Battery

1. De-energize the AC power.

2. Disengage the housing cover from the backplate.

3. Disconnect the battery leads from the charger circuit board.

4. Remove the battery from the clips inside the cover.

5. Replace with a

new battery (see unit model label for correct part number) and reconnect leads.

6. Reassemble cover to backplate.

Replacing LED Lamps

The LED lamps inside the unit are not replaceable or field serviceable. Please see progresscommercial .com for further assistance.

Troubleshooting

Emergency circuit does not work

• Batteries are shipped uncharged and disconnected. Connect battery leads and charge 24 hours before testin

• Make sure the charger board and test button/light pipe are properly seated and aligned.

• Check wiring connections.

Hubbell Lighting, Inc. Life safety Products • www.dual-lite.com

Printed in U.S.A.

93033106_A 2/11

RECYCLING INFORMATION

All steel, aluminum, and thermoplastic parts are recyclable.

NOTICE: Emergency units contain rechargeable batteries which

st be recycled or disposed of properly.