Installation Guide

FIXTURE INSTALLATION

Connect both batteries to the circuit board as shown. Connect

either battery to the left or right header.

93067921

Step 1

Step 2

Step 3

The

PECEM

is packaged with the

rectangular face attached. If so

desired, remove the rectangular

face and replace it with the round.

The PECEM unit is equipped

with intelligent wiring.

Connect the black wire from

the unit to the hot building

wire (120-277VAC 50/60Hz),

the white wire to the

neutral building wire, and the

building ground to the green

ground wire mounted inside

the enclosure. Secure all

with wire nuts.

All

wires and components not shown

for clarity.

Make sure the jumper is installed as shown, leaving the third pin

away from the batteries exposed.

93067922

Step 4

93067924

Tuck wires neatly in and insert fixture into

the backbox and screw the assembly in place.

Tilt the adjustable LED assemblies to your ceiling

height as shown below:

1 2 3 4

4 3 2 1

12' ceiling - position 4

11' ceiling - position 3

10' ceiling - position 2

9' ceiling - position 1

Step 5

Test

Button

93067921

93067923