Installation Guide

IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed, including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. CAUTION – To prevent electrical shock, do not mate unit connector until installation is complete and A.C.
power is supplied to the unit.
2. CAUTION – This fixture provides more than one power supply output source. To reduce the risk of
electrical shock, disconnect both normal and emergency sources by turning off the A.C. branch circuit
and by disconnecting the unit connector.
3. CAUTION – This is a sealed unit. The integral, high temperature Ni-Cad battery is not replaceable. Replace
the entire unit when necessary. The EPA certified RBRC
®
Battery Recycling Seal indicates that IOTA
Engineering is voluntarily participating in an industry program to collect and recycle these batteries at the
end of their useful life, when taken out of service in the United States or Canada. The RBRC program
provides a convenient alternative to placing used Ni-Cad batteries into the trash or the municipal waste
stream, which may be illegal in your area. Please call 1-800-822-8837 for information on Ni-Cad battery
recycling and disposal bans/restrictions in your area. IOTA Engineering’s involvement in this program is
part of our commitment to preserving our environment and conserving our natural resources.
4. DO NOT USE OUTDOORS. The I-42-EM-A is for use with grounded, UL Listed, indoor fixtures except in
heated air outlets or hazardous locations.
5. The I-42-EM-A requires an unswitched A.C. power source of either 120 or 277 volts. Properly cap the
unused A.C. lead.
6. Do not mount near gas or electric heaters.
7. The I-42-EM-A should be mounted in locations and at heights where it will not readily be subjected to
tampering by unauthorized personnel.
8. The I-42-EM-A will cold strike and operate one 10W through 42W, or two 10W through 26W, 4 pin Rapid
Start compact fluorescent lamps. Contact customer service for additional lamp usage.
9. The I-42-EM-A is compatible with most electronic A.C. ballasts (including multiple lamps) as follows:
Electronic ballasts – one or two lamp emergency operation.
10. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
11. Do not use this equipment for other than intended use.
12. Install in accordance with the National Electrical Code and local regulations.
13. Installation and servicing should be performed by qualified personnel.
14. Lighting fixture manufacturers, electricians, and end-users need to ensure product system compatibility
before final installation.
SAVE THESE INSTRUCTIONS
INSTRUCTION MANUAL
C US LISTED
U
L
R
I-42-EM-A
SERIES D
10W–42W RAPID START
4 PIN COMPACT LAMP
EMERGENCY LIGHTING EQUIPMENT
P.O. BOX 11846 TUCSON, AZ 85734 • 1301 E. WIEDING ROAD TUCSON, AZ 85706
[phone]
• FAX [phone]
www.iotaengineering.com