OGRESS P860058-030, P860058-031, SERIES LIGHTING” i , Cylinder Cord Replacement Kit PACKAGE CONTENTS PART| DESCRIPTION QUANTITY A | Cord 1 B | Wire nut 3 ATTACH YOUR RECEIPT HERE Purchase Date AN Safety Information Please read and understand this entire manual before attempting to assemble, operate or install the product. CAUTION: Read instructions carefully and tum electricity off at main circuit breaker panel before beginning installation. CAUTION: Risk of fire. Min. 80°C supply conductors.
Assembly Instructions for LED Version 1 1. Use screwdriver to loosen the plastic screw (C). Unscrew the threaded nut (D) located on the top of the cylinder(E). © Plastic screw & X1 (D) Threaded nut bo x1 ® province Loosen plastic screw(F) from plastic wire clip and remove cord from canopy assembly(G). Feed cord into cylinder (E) which will drop out the light engine assembly. (F) Plastic screw X1 © Canopy assembly X1 3 3. Cut WHITE wires, BLACK wires and GREEN wires to remove orange connectors.
Assembly Instructions for LED Version 4 4. Measure desired installation height for fixture and cut cord to length leaving extra length to make electrical connections. Feed new cord (A) down through metal tube(!) and out the tube opening. Install strain relief (H). Strip 3/8" of insulation from the electrical wire ends. Use wire nuts (B) to connect the wires, BLACK to BLACK, WHITE to WHITE, GREEN to the ground wire. Wire nut (= x3 (H) Strain relief x1 5.
Assembly Instructions for Incandescent Version 1. Use screwdriver to loosen the plastic screw (C). Unscrew the threaded nut (D) located on the top of the cylinder(E). © Plastic screw © X1 (D) Threaded nut BB x1 (E) Cylinder 0] X1 2. Loosen plastic screw(F) from plastic wire clip and remove wire from canopy assembly(G). Feed cord into cylinder (E) which will drop out the socket assembly. (F) Plastic screw a © Canopy assembly Connectors 3.
Assembly Instructions for Incandescent Version 4 4. Measure desired installation height for fixture and cut power cord to length leaving extra length to make electrical connections. Feed new cord (A) down through tube opening of socket assembly. Install strain relief (H). Strip 3/8" of insulation from the electrical wire ends. Use wire nuts (B) to connect the wires, BLACK to BLACK, WHITE to WHITE, GREEN to the GREEN wire. Wire nut (= x3 (H) Strain relief x1 5.
