Installation Sheet
Figure 1 Figure 2
Figure 3
Frequency switches
Receiver
ON
Frequency switches
Transmitter
ON ECE
1 2 3 4
2. INSTALLING RECEIVER IN CEILING FAN
A. Safety Precautions:
* WARNING: HIGH VOLTAGE! Disconnect source of electrical power by removing fuse or switching off circuit breaker.
* Do not use with solid state fans.
* Electrical wiring must meet all local and national electrical code requirements.
* Electrical source and fan must be 115/120 volt, 60 Hz. Maximum fan motor amps: 1.0, Maximum light watts: 250 - incandescent only.
* Household electrical power can cause serious injury or death!
B. Installing Receiver in Fan:
a. Remove electrical power from the circuit.
b. Remove ceiling fan canopy from the mounting bracket.
c. Disconnect existing wiring between ceiling fan and supply at electrical junction box.
d. Make connections as follows, using the wire nuts supplied: (Figure 3)
CONNECT TO
Green fan wire......................................Bare supply wire
Black receiver wire (AC IN L)................Black supply wire
White receiver wire (AC IN N)...............White supply wire
White receiver wire (TO MOTOR N)......White fan wire
Black receiver wire (TO MOTORL L) ....Black fan wire
Blue receiver wire (FOR LIGHT)............Blue light wire
If other fan or supply wires are different color, have this unit installed by qualified licensed electrician.
e. Push all connected wires up into junction box.
f. Lay the black antenna wire on top of the receiver, and put the receiver in the mounting bracket.
g. Reinstall the canopy on the mounting bracket.
h. Restore electrical power.
A. Setting the code on the transmitter:
a. Removed battery cover. Press firmly below arrow and slide battery over off.
b. S
lide code switches to your choice of up or down position. (Factory setting is all up.) Do not use this position. Use a small
screwdriver or ball point pen to slide firmly up or down (Figure 1).
B. Setting the code on the receiver:
a. Slide code switches to the same positions as set on your transmitter (Figure 2).
b. Replace battery cover on transmitter.
1
REMOTE CONTROL
GENERAL INFORMATION
2661
***********************************************************************************************************************************************************
CAUTION - Read instructions carefully and turn electricity off at service entrance before installing, wiring, or servicing this product.
WARNING - Do not energize electrical supply circuit to receiver until all connections have been made and tested in
accordance with all applicable electric codes.
WARNING - This product contains chemicals known to the State of California to cause cancer, birth defects and /or other
reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
***********************************************************************************************************************************************************
This remote control is designed to separately control your ceiling fan speed and light brightness.
Ther
e are four buttons (HI, MED, LOW, OFF) to control the fan speed and off.
The light dimmer button will control the light brightness dimmer and off.
The red indicator on the transmitter will light when the button is pressed.
INSTALLATION AND OPERATING INSTRUCTION
1. SETTING THE CODE:
This unit has 16 different code combinations. To set the code, perform these steps:
AC SUPPLY
BLACK
WHITE
BARE GREEN
WHITE
WHITE
BLUE BLUE
BLACK
BLACK
RECEIVER
93092382_A