Instructions / Assembly

Installing the Light Kit
Pan/Light Kit Fitter
Assembly/ Shatter-
Resistant Shade
CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit
to the fan before installing the light kit.
1. Loosen but do not remove two of three
mounting screws from the fan motor
assembly; Remove one mounting screw.
(Figure 14)
2. Push the light kit pan up to the fan motor
assembly so that the two loosened screw
heads t into the keyhole slots. Turn the
light kit pan clockwise, tightened the
screws. Re-install the screw that was
removed in step 1 and tighten rmly.
(Figure 14)
3. Remove one screw from the light kit pan
and loosen, but do not remove the other
two screws. Connect the wires from the
light kit tter assembly to the wires from
the fan motor assembly by connecting the
molded adaptor plugs together. Carefully
tuck all wires and splices into the switch
cap. (Figure 15)
4. Push the light kit tter assembly up so
that the two loosened screw heads t into
the keyhole slots. Turn the light kit tter
assembly clockwise, tighten the screws. Re-
install the screw that was removed in step 3
and tighten rmly. (Figure 15)
5. Place the shatter-resistant shade into the
light kit pan, aligning the three at areas on
the top of the shatter-resistant shade with
the three raised dimples in the light kit pan.
Turn the shatter-resistant shade clockwise
until it stops. (Figure 16)
Light Kit
Pan
Mounting
Screw (3)
Black
White
Mounting
Screw (3)
Light Kit Fitter
Assembly
Blue
White
Molded
Adaptor Plugs
Figure 14
Figure 15
PERIODICALLY CHECK THE SHATTER-
RESISTANT SHADE IS SEATED FULLY
CLOCKWISE IN THE LIGHT KIT PAN
ASSEMBLY.
9.
Figure 16
Raised
Dimples
Flat Area
Shatter-
Resistant
Shade