Instructions / Assembly

Attaching the Fan
Blades
1. Attach a blade arm to a blade by aligning
three screw holes in the blade arm with the
screw holes in the blade and secure with
screws provided; Attach a blade decorative
bar to the blade by aligning six screw
holes and one alignment post in the blade
decorative bar with the holes in the blade
and secure with screws provided; Repeat
for the remaining blades. (Figure 11)
2. Insert a blade assembly to the slot cut-off
in the center ywheel, align the three screw
holes in the blade assembly with the screw
holes in the ywheel and secure with the
screws provided. Repeat for the remaining
blade assemblies. (Figure 12)
Figure 11
Finishing the Fan
Installation
STANDARD CEILING MOUNTING
1. Align the locking slots of the ceiling
canopy with the two screws in the
mounting plate. Push up to engage the
slots and turn clockwise to lock in place.
Immediately tighten the two mounting
screws rmly.
2. Install the remaining two mounting screws
into the holes in the canopy and tighten
rmly.
3. Install the decorative canopy ring by
aligning the ring’s slots with the screws in
the canopy. Rotate the ring clockwise to
lock in place.
4. You may now proceed to attaching the
fan blades.
WHEN USING THE STANDARD BALL/DOWNROD
MOUNTING, THE TAB IN THE RING AT THE
BOTTOM OF THE MOUNTING PLATE MUST
REST IN THE GROOVE OF THE HANGER BALL.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
7.
Blade
Screws
Screws
Blade Arm
Blade
Decorative
Bar
Alignment Post
Figure 12
Blade
Blade Arm
Blade Decorative Bar
Screws
Flywheel
Slot Cut-off for
Blade Insert