Installation Guide

Installing the Light Kit
Pan/Light Kit Fitter
Assembly/Glass Bowl
CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit
to the fan before installing the light kit.
THE GLASS IS FRAGILE, USE CARE WHEN
INSTALLING THE LIGHT KIT AND THE
GLASS SHADE
1. Loosen but do not remove two of three
mounting screws from the fan motor
assembly; Remove one mounting screw.
(Figure 13)
2. Push the light kit pan up to the fan motor
assembly so that the two loosened screw
heads t into the keyhole slots. Turn the
light kit pan clockwise, tightened the
screws. Re-install the screw that was
removed in step 1 and tighten rmly.
(Figure 13)
3. Remove one screw from the light kit pan
and loosen, but do not remove the other
two screws. Connect the wires from the
light kit tter assembly to the wires from
the fan motor assembly by connecting the
molded adaptor plugs together. Carefully
tuck all wires and splices into the switch
cap. (Figure 14)
4. Push the light kit tter assembly up so
that the two loosened screw heads t into
the keyhole slots. Turn the light kit tter
assembly clockwise, tighten the screws. Re-
install the screw that was removed in step 3
and tighten rmly. (Figure 14)
5. Remove the rubber washer, hex nut and
nal from the threaded nipple of the light
kit tter assembly. Position the glass bowl
over the threaded nipple. Re-install the
rubber washer, hex nut and nial to the
threaded nipple to secure the glass bowl
properly. (Figure 15)
Mounting
screw
Figure 13
Figure 14
8.
Figure 15
DO NOT OVER TIGHTEN THE HEX NUT. OVER-
TIGHTENING THE HEX NUT MAY CAUSE THE
GLASS TO BREAK.
NOTE