Installation Guide

9.
Installing the Light
Kit/ Glass Bowl
CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit
to the fan before installing the light kit.
THE GLASS IS FRAGILE, USE CARE
WHEN INSTALLING THE LIGHT KIT AND
THE GLASS SHADE.
1. Loosen but do not remove three of four
mounting screws from the light kit adaptor
below the fan motor assembly; remove one
mounting screw. (Figure 13)
2. Connect the blue and white wires exiting
the light kit adaptor with the black and
white wires from the light kit assembly by
engaging the molded adaptor plugs (blue to
black; white to white).
3. Carefully tuck connectors into the light
kit adaptor. Position the light kit assembly
onto the light kit adaptor, aligning each of
the four holes. Rotate the light kit assembly
clockwise to engage the three mounting
screws with the three key hole slots, tighten
the screws. Re-install the one mounting
screw that was removed in step 1 and
tighten rmly.
4. With power off, install the two uorescent
bulbs (Max. 13W or equivalent LED or
incandescent bulbs) by screwing into the
light bulb sockets. (Figure 14)
5. Place the glass shade into the light kit
assembly, aligning the three at areas
on the top ange of the glass shade with
the three raised dimples in the light kit
assembly. Turn the glass shade clockwise
until it stops. (Figure 14)
Glass
Light Kit
Assembly
Bulbs(2)
(Provided)
Dimples
Raised
Flat Area
Figure 13
Figure 14
PERIODICALLY CHECK THE GLASS IS
SEATED FULLY CLOCKWISE IN THE LIGHT KIT
ASSEMBLY.
ALLOW THE BULB TO COOL COMPLETELY
BEFORE TOUCHING OR REPLACING THE
BULBS TO AVOID ACCIDENTAL BURNING OF
THE SKIN.