Instructions / Assembly

Installing the Mounting
Plate
Step 1. Remove 1 of the 3 screws from the
mounting ring and loosen the other 2 screws.
(Do not remove)
Step 2. Place the key holes on the mounting
plate over the 2 screws previously loosened
from the mounting ring, turn mounting plate
until it locks in place at the narrow section of
the key holes. Secure by tightening the 2
screws previously loosened and the one
previously removed. (Fig. 17)
Installing the Switch
Housing
N O T E : B e f o r e s t a r t i n g i n s t a l l a t i o n ,
disconnect the power by turning off the
circuit breaker or removing the fuse at fuse
box. Turning power off using the fan switch is
not sufficient to prevent electric shock.
1. Remove the screws from the mounting
plate under the fan motor.
2. While holding the switch housing under
y o u r f a n , s n a p t o g e t h e r t h e w i r e
connection plug. (Fig. 18)
3. Raise the switch housing to the mounting
plate until the holes in switch housing and
mounting plate line up. Reinsert screws to
secure in place. (Fig. 18)
Mounting
plate
Mounting ring
Screws
Switch
housing
Connection plug
Mounting ring
Screws
Figure 17
Figure 18
9.