Installation Guide

Installing the Light Kit
1. Remove and retain the three mounting screws
from the switch housing cover of the light kit tter
assembly (Figure 13).
2. Locate the blue and white wires inside the switch
housing and switch housing cover of the light kit
tter assembly. (Figure 13)
3. Connect the blue wire from the ceiling fan switch
cup to the black wire from the light kit.
4. Connect the white wire from the ceiling fan
switch cup to the white wire from the light kit by
connecting the molded plugs together. (Figure 13)
5. Attach the switch housing cover with light kit
tter to the switch housing using the three screws
that were previously removed in step 1.
6. Place the shatter resistant shade into the light kit
assembly, aligning the three at areas on the top
ange of the shatter resistant shade with the three
raised dimples in the light kit assembly. Turn the
shatter resistant shade clockwise until it stops.
(Figure 14)
7. With the power off, install the four LED bulbs
(max. 9W, included) into the light socket. (Figure
15)
8. Attach the pull chain extensions to the fan switch
and light switch pull chains. (Figure 16)
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DISCONNECT THE ELECTRICAL SUPPLY
CIRCUIT TO THE FAN BEFORE INSTALLING
THE LIGHT FIXTURE.
Figure 13
Figure 14
Figure 15
Figure 16
8.
Blue
Molded adaptor plugs
White
Black
White
Switch
housing
cover
Light kit
fitter assembly
Switch
housing
Shade
Fob
pendant
Reverse
switch