Installation Guide

Installing the battery
Install 12V A23 battery (included),
To prevent damage to transmitter, remove the battery
if not used for long periods. (Fig. 16)
Figure 16
Restore power to ceiling fan and test for proper
operation.
1. "
○
,
○○
,
○○○
, "buttons:
These three buttons are used to set the fan
speed as follows (Fig. 17):
○
= Low speed
○○
= Medium speed
○○○
= High speed
2. "  " button:
This button turns the fan off.
3. The " " button turns the light ON or OFF and also
controls the brightness setting. Press and release the
button to turn the light ON or OFF. Press and hold the
button to set the desired brightness. The light key has an
auto-resume, it will stay at the same brightness as the
last time it was turned off.
Figure 17
7. Operating Your Transmitter
Installation of Transmitter Wall
Mount Holder with one screw.