Installation Guide

5.
Make the Electrical
Connections
WARNING: To avoid possible electrical shock,
be sure electricity is turned off at the main fuse
box before wiring.
WARNING: Check to see that all connections
are tight, including ground, and that no bare wire
is visible at the wire nuts, except for the ground
wire.
CAUTION: To reduce the risk of electric shock,
this fan must be installed with an isolating wall
control/switch.
NOTE: The fan must be installed at a maximum
distance of 20 ft. from the remote control for
proper signal transmission between the remote
control and the fan's receiving unit.
If you feel you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
Follow the steps below to connect the fan to your
household wiring. Use the plastic wire nuts with
your fan. Secure the plastic wire nuts with
electrical tape. Make sure there are no loose
strands or connections.
Figure 8
Step 1. Insert the receiver into the mounting
bracket with the flat side of the receiver facing the
ceiling.
Step 2. Make wire connections from the fan to the
receiver.
From Fan To Receiver
White Wire ---------White Wire "For Light"
Blue Wire
----------Blue Wire "For Light"
Yellow Wire
-------Yellow Wire
Red Wire
---------- Red Wire
Grey Wire
--------- Grey Wire
Step 3. Make wire connections from the filter to the
outlet box as follows, using the wire nuts.
From Filter To Outlet Box
Black Wire "AC in L" ------Black Wire (Hot)
White Wire "AC in N"------White Wire (Neutral)
From Fan, Filter & Receiver To Outlet Box
Green Wires* ----- Green or Bare Wire (Ground)
*
There are four green grounding leads: from the
mounting bracket, hanger ball/downrod assembly,
receiver and the filter.
Step 4. Turn the wire nut connections upward,
spreading them apart so the green (ground) and white
wires will be on one side of the outlet box and the black
and blue wires will be on the other side. Carefully tuck
the connections up into the outlet box.
White
White
White
Canopy
Black
Black
Black
Filter
Receiver
Outlet Box
White
White
Blue
Blue
Red
Red
Yellow
Yellow
Grey
Grey
Green
Green
Green
Ground conductor
Green
Green