Installation Sheet

Finishing the Installation
Step 1. Tuck connections neatly into ceiling
outlet box.
Step 2. Slide the canopy up to mounting bracket
and place the key hole on the canopy over the
screw on the mounting bracket, turn canopy until
it locks in place at the narrow section of the key
holes. (Fig. 12)
Step 3. Align the circular hole on canopy with the
remaining hole on the mounting bracket, secure
by tightening the two set screws. Note: Adjust the
canopy screws as necessary until the canopy and
canopy cover are snug.
WARNING
Make sure the notch on the hanging bracket
properly sits in the groove in the hanger ball
before attaching the canopy to the bracket by
turning the housing until it drops into place.
Figure 12
Figure 13
Figure 14
Outlet box
Hanger
bracket
Canopy
Canopy cover
Screws
7.
Attaching the Fan Blades
Step 1. Attach the blades to the blade arms using
three decorative nuts, screws and fiber washers by
lining up the grooves of the decorative nut with
the ridges on the blade arms. (Fig. 13)
Step 2. Start a screw into the blade arm, do not
tighten. Repeat for the 2 remaining screws and
washers. Tighten each screw securely starting
with the center screw. Make sure the blade is
straight.
Step 3. Fasten the blade assembly to the motor
using the motor screws provided. (Fig. 14)
Step 4. Repeat these steps for the remaining
blades.
Screws
Blade arms
Blades
Blade arms
Decorative
nuts
Grooves
Screws with
fiber washers
Ridges