Installation Sheet

4.
Attaching the Fan Blades
1. Put the fan upside down as shown. Attach
the blades to the fan motor assembly by
aligning the notches on the blades with
alignment post on the ywheel and put
the blade on to the ywheel, secure with
screws and tighten it.
2. Repeat these steps for remaining blades.
(Figure 5)
3. Flip the fan right side up as shown.
Tighten the blades to the ywheel by
installing the screws to the side of
ywheel. (Figure 6)
4. Make sure all the screws are rmly
tightened. (Figure 6)
Screws
Blade
Bottom of
fan motor assembly
Top of fan
motor assembly
Figure 5
Figure 6
Figure 7
Motor Assembly
Screws
Decorative
Ring
Attaching the Decorative
Ring
1. Remove the three screws from the tab of
fan-motor assembly. Attach the decorative
ring to the fan -motor assembly by
aligning the holes on decorative ring
with the holes on the tab, and install the
screws.
2. Make sure all the screws are rmly
tightened. (Figure 7)
Motor Assembly
Screws
Blade