Installation Sheet

Operating Your Transmitter 10.
Figure 17
Figure 16
Your DC brushless motor is equipped with an
automatically learned type remote control. There is
no frequency switches on the receiver or transmitter.
The fan can start to use once the pairing process is
done.
Remote Control Button Definitions:
These six buttons are used to set the fan speed as
follows:
I = minimum speed
II = low speed
III = medium low speed
IV = medium speed
V = medium high speed
VI = high speed
button: Turns the fan off.
button: Controls fan direction.
button: This button is to control optional light on or off.
Press and hold the button to activate the dimmer function.
Setting the Remote Control
Follow the below steps to set the remote control:
The auto learning function will only mandate within
60 seconds when turning the fan’s AC power ON.
With the fan’s power off, restore power to the fan. Press
and hold “SET” button for about 5 seconds and release.
If optional light kit is installed, the light kit will flash
twice and the signal light on the remote control will
come on when the button is pressed. The fan has
completed the pairing process with the remote control
and is ready for use.
NOTE: If the self calibration test failed, turn
the AC power off; restore power and process
the self calibration test again.
NOTE: During self calibration test, the remote
is non-fuctional.
NOTE: The learning frequency function and
self calibration test will continue to retain the
last set frequency and calibration set even
when the AC power is shut off. If the
frequency is changed the self calibration test
will occur again.
Over 80W protection: When the receiver
detects motor power consumption which is
greater than 80W, the receiver power will be
stopped and operation will immediately
discontinue. Wait for 5 seconds and then turn
the receiver power back on.