Operation Manual

49
© Prognosys Medical Systems Private Limited│ X-Ray Products
4.2 Detector Connection
PRORAD detector can be connected to system either by wireless or by wire cable.PRORAD FPD use
Dynamic Host Configuration Protocol (DHCP) to assign IP address automatically.
4.2.1 Wire connection
The default address of PRORAD is 192.168.11.100. User need to set the computer to the same
domain as PRORAD. First, open the IPV4 of computer's local network management interface, and
change the IP address to 192.168.11.1 and subnet mask to 255.255.255.0.
After connection established, open Cmd.exe and enter ‘ping 192.168.11.100’ then press enter to
check the network. If success, there is a reply from FPD as below.