Operation Manual

47
© Prognosys Medical Systems Private Limited│ X-Ray Products
Caution
_________________________________________________________________________________
4.1.4 Charging the Battery Pack for the Flat Panel Detector
Use the battery charger recommended by Prognosys Medical Systems Private Limited.. For details
on operations, refer to the instruction manual for the battery charger.
4.1.5 Installing/Removing the Battery Pack for the Flat Panel Detector
Follow the procedure below to install/remove the battery pack for the flat panel detector. When
installing/removing the battery pack, place the flat panel detector on a flat place.
Do not remove the battery pack until a processed image appears in the window of the image
processing unit after the exposure.
Do not place the connector
on a hard surface such as
the edge of a bed.
Make sure that the connector
does not protrude from the
edge of a bed.
Do not raise the flat panel
sensor by holding only the
connector.