Operation Manual

30
© Prognosys Medical Systems Private Limited│ X-Ray Products
by heat.
Do not take image while FPD is in busy state, patient might need to retake.
Make sure use the right FPD when mutiple FPD are standby in the same time, use wrong FPD will
result in patient retake.
The orange light is on, not only means that there is a problem with the FPD, but it may also mean
that the internal image storage space is full. Please use the INCX Service tool to clear the image in
the memory before continuing to use it.
Do not install software other than this product on the computer, including other software of the
hospital system, to avoid compatibility problems.
_________________________________________________________________________________
2.16 Disposal of Waste
It is illegal to place the device in the trash. Please contact the qualified local recycling provides
before disposing the device, The disposal procedure should comply with local law.
2.17 Product Labels
The information of each label can be found in this section and the corresponding location are also
presented as the following figure. The following labels are adhered to the PRORAD X-Ray Flat Panel
Detector.