Operation Manual

Although the flat panel detector conforms to IPX6, no warranty is given as to the prevention of

water intrusion in the flat panel detector. If the flat panel detector is splashed with water, wipe off

moisture and ensure that the flat panel detector is completely dry before use.

As the cables of the equipment are long, be careful not to entangle the cables during use. Also, be

careful not to trip over the cables. Falls could result in injury.

Follow the specified procedure when turning off the equipment. Otherwise, the flat panel detector

could be damaged by thermal shock.

External equipment intended for connection to signal inputs, signal outputs or other connectors

shall comply with the relevant product standard e.g. IEC 60950-1 or IEC 62368-1 for IT-equipment

and the IEC 60601-series for Medical Electrical Equipment. In addition, all such combinations –

Medical Electrical Systems – shall comply with the safety requirements stated in the general

standard IEC 60601-1, edition 3, clause 16. Any equipment not complying with the leakage current

requirements in IEC 60601-1 shall be kept outside the patient environment i.e. at least 1.5 m from

the patient support or shall be supplied via a separation transformer to reduce the leakage

currents.

Any person who connects external equipment to signal inputs, signal outputs or other connectors

has formed a Medical Electrical System and is therefore responsible for the system to comply with

the requirements. If in doubt, contact qualified medical technician or your local representative.

Do not place FPD near strong EMI sources, it might cause line defect in the image, and patient need

to retake x-ray.

Careful when holdinig the FPD, drop or impact will result in water come inside causing short circuit,

which might have patient retake x-ray.

Do not operate the FPD beyond the limited temperature, patient might need to retake or harmed