Operation Manual

14
© Prognosys Medical Systems Private Limited│ X-Ray Products
- Install the equipment in a location where it will not be exposed to water.
- Check that the equipment is securely earthed.
- Check that all of the cables are completely and securely connected.
- Keep the control cabinet out of reach of patients.
Cautions
Do not reverse conneting positive and negative power terminal, it might cause short circuit and
patient/user will be harmed.
_________________________________________________________________________________
2.4 Electric Shock Hazard
_________________________________________________________________________________
Warning
Observe the following precautions when using the cables:
- Do not touch the plug and connector with wet hands. Otherwise, electric shock may result
causing death or severe injury.
- Hold the plug or connector when removing the cable.
- Pulling the cable or carrying by holding it may damage the cable, causing fire or electric shock.
- Do not damage or remodel the cable.
- Do not place a heavy object on the cable or lay it under the flat panel detector. Do not step on,
pull, forcibly bend, or bundle the cable. Otherwise, fire or electric shock may result.
- Do not use the flat panel detector for the radiographic
examination stand if its cable becomes overloaded. Otherwise,
the cable may be damaged, causing fire or electric shock.
- Do not touch the back-up cable connector of PRORAD,