User's Manual

16
CAUTION
Only use MARK 2 in a dry Charging Station S and
only touch with dry hands!
This may otherwise lead to the Charging Station S
not functioning properly.
 The pins face down.
Insert MARK 2
in the Charging Station S.
RESULT
MARK 2 pulses red and charges in the Charging
Station S.
NOTE
The LEDs pulse red while in charging mode. When
the battery is fully charged, the LEDs pulse green. It
takes about 2 hours to charge MARK 2.
CAUTION
Only touch the Access Point One S with dry hands!
This may otherwise lead to the Access Point One S system not
functioning properly.
NOTE
The following steps are only needed when connecting via
868/915 MHz.
For a connection via BLE HID; see p. 18
CONNECTION WITH USB CABLE IN USB HID MODE:
1. Connect the USB cable with the
end device.
2. Plug the other end of the USB
cable into the RJ45 socket of the
Access Point One S.

the correct fastening.
RESULT
The LED of the Access Point One S lights up green. The
Access Point One S is connected to the end device.
SETUP OF MARK 2 SYSTEM
1
ST
STEP: CHARGE MARK 2 2
ND
STEP: CONNECT THE ACCESS
POINT ONE S (868/915 MHZ)